Sealant applicators in Conyer
We carry out sealant work for offices, shops, hotels and other commercial buildings in Conyer and the surrounding area. Send photographs or drawings for a fixed quote.
- Gaps behind commercial kitchen worktops and sinks
- Wall and floor joints that have lost their seal
- Layers of sealant, all of them failing
Commercial sealant contractors for Conyer sites
Photos, a specification or a quick description of the joints is enough to start a fixed quote.
Common problems we fix in Conyer
If sealant tears through its centre, it has failed cohesively. That normally means the joint stretched further than the product could cope with because the bead was too thin, the joint over-stretched or the movement class wrong. Replacing it like for like rarely holds.
Most enquiries start with one or more of the following:
- A top-up bead over failed sealant, now lifting
- Frame mastic that has hardened and come away from the wall
- Untidy joints in a reception, shop floor or lobby
- External beads that have gone brittle and cracked
For any commercial premises in Conyer, a lasting joint depends on full removal of the old sealant and clean, dry faces.
Questions to ask before you book
- Whether primer will be used where the manufacturer specifies it
- What level of public liability insurance do they hold?
- Is the sealant right for the movement and the substrate?
- How the existing material will be dealt with
Commercial mastic work in Conyer
If you look after more than one building, a single sealant contractor saves a lot of chasing. We take on one-off reseals, runs of jobs across a portfolio and planned maintenance programmes, run the same way on every site: send details, get a fixed quote, we seal, and a 12-month guarantee once it’s signed off. For sites in Conyer, the quickest start is to give us a call on 01277 525 020 or email us with a list of addresses. Most enquiries involve smeared sealant across finishes from a rushed job and frame sealant that has cracked, shrunk or pulled away, across kitchen worktops and splashbacks, washrooms and tea points and external facade joints. Searching for sealant specialists in Conyer? Mastic Doctor has worked for contractors, FMs and building owners since 2005, CHAS accredited and a Constructionline member.
In an occupied building in Conyer, the job is planned so areas stay in use: we agree the order with you and hand back each area with its cure time.
A job in a smaller place like Conyer is usually a single building. We plan the visit so everything on the list is done in one go, with the right products and colours on hand.
The 12-month guarantee covers our workmanship: preparation, application and finish. It doesn’t extend to damage, other trades’ later work or movement the joint was never designed to take.
- Place
- Conyer (ME9)
- Wider area
- Kent
- Guarantee
- 12 months on our workmanship
- Price
- Quoted before any work starts
- Telephone
- 01277 525 020
- Page updated
- 3 November 2026
Keeping the joints sound
Cleaning and maintenance staff play a part too. Share these points with them:
- Brief cleaning contractors to avoid scourers and blades on sealant
- Put external and wet-area joints on a regular inspection round
- Don’t let cleaning or traffic back on before the cure time is up
- Check the asbestos register before anyone disturbs old sealant in an older building
Keep an eye out for other trades after we have gone. When fittings are moved or cabling added, the sealant nearby is easily disturbed. Where work has disturbed a joint, just ring 01277 525 020 or send details through our quote form for a quote.
Sealant rarely fails all at once across a building. The first failures are often a warning about the rest. We will tell you which sealant joints need doing first and which can wait.
Other services in Conyer
Honest limits
We check first that sealant really is the fix. It won’t put right:
- Roof leaks that only look like a joint problem
- A dripping trap, valve or pipe behind a fitting
- Suspect materials that need testing and specialist removal
Not sure which it is? You can call the office on 01277 525 020 or email a schedule or drawings and we will tell you honestly before you book.
What we seal
- Washrooms and tea points
- Kitchen worktops and splashbacks
- Movement joints in walls and floors
- Window and door perimeters
- External facade joints
- Floor and threshold joints
What Conyer’s businesses ask us to seal
The sea is no more than about 1 mile from Conyer. For shops, hotels and offices, that means frontage and frame joints that weather faster than they would inland. We choose a product rated for the exposure, then confirm the colours available for it. Rainfall across the South East, Conyer included, is lower than in many parts of the UK. Even so, outside sealing waits for a dry joint, and cold, damp mornings can delay it.
Offices and shops close to stations such as Teynham station, 1.1 miles to the south of Conyer, tend to be busy all day, so sealant work is planned around opening hours.
Conyer is about 4 miles east of Sittingbourne, in Kent. We send applicators to Conyer for sealant joints, handled exactly as we handle every other area. 931 places across Kent fall within our area, including Conyer. Our London page has more on work in that area, about 41 miles away.
Commercial sites across ME9 are covered for sealant joints. Streets here include North Quay and Conyer Road. If your building is just outside Conyer, we cover Teynham Street (1 mile south-east), Deerton Street (1 mile south-east), Teynham (1 mile south), Norton Ash (2 miles south) and Lewson Street (2 miles south). Nearby towns on our patch include Maidstone (14 miles south-west), Ashford (15 miles south), Canterbury (12 miles south-east), Sittingbourne (4 miles west), Whitstable (9 miles east) and Faversham (4 miles south-east).
Around Conyer
The nearest railway station is Teynham station, about 1.1 miles south. Nearby you’ll also find Dolphin Sailing Barge Museum (3.1 miles west) and Castle Rough (2.8 miles west).
How a job runs
Where the site stays busy, the work is phased so only one area is out of use at a time. Each section is protected, cleaned back and sealed, then handed back before we move to the next. Smaller jobs around Conyer can be grouped with others nearby, which keeps travel down. You’ll have a fixed quote before work starts.
- First, details reach us through the quote form or a site visit.
- We diagnose the cause of failure and price a fixed scope.
- Where parts of the building must stay open, the work is phased.
- Every failed bead is removed rather than covered.
- Each joint gets a suitable sealant, laid to depth and tooled.
- We check the work with you, and the 12-month guarantee starts.
Preparing the site
- Let us know about inductions and permits
- Move anything stored against the joints
- Warn occupants and staff about the work
Request a quote
Send us photographs, drawings or a joint schedule are often enough for a fixed quote. Where a site visit makes more sense, we will arrange one.
Read more
Owners, agents and contractors
Building owners and managing agents use us on everything from one building to a spread of sites around Conyer. One quote can cover more than one site, so there’s one set of paperwork to deal with.
For main contractors, we work as the sealant subcontractor. Programme, specification and site rules come first.
Quoting for work in Conyer
The price varies from site to site. It mainly depends on:
- How much existing material needs removing
- Joint width, depth and condition
- How much there is to seal
- Working within restricted access windows
Pricing sealant joints depends on how many there are, their condition and the access, and any specification that applies. Ask us for a fixed quote.
What we need to price the job
Whether it’s one area or a whole building, the same details help:
- Specification clauses that apply
- Asbestos survey details if the building is older
- How the joints are reached, and at what height
- Drawings or a marked-up plan, if available
Every job follows the same four steps: send details, get a quote, we seal, guaranteed. To take the first step, speak to us on 01277 525 020 or use the quote form.
Questions we’re asked in Conyer
Can you match sealant colours for premises in Conyer?
Yes, we can typically get close to most finishes from the product’s colour range. Send colour references or photographs and we’ll confirm what’s available for the product.
Is Conyer too small for you to travel to?
Not at all: smaller places are covered as well as towns. We work across Greater London and the South East. Good photos up front let us bring everything on the first visit.
Which sealant will you use?
Where there’s a specification, we use the product it names. If not, we choose for the movement, the surfaces and the conditions, in line with the manufacturer’s guidance.
Are you CHAS accredited and on Constructionline?
Yes. Mastic Doctor is CHAS accredited and a Constructionline member.
Can you supply RAMS and insurance details?
We confirm documents at quote stage: most clients ask for RAMS, our insurance certificate and CSCS details. Our applicators are CSCS-carded.
Is failed sealant stripped out, or sealed over?
Every failed bead is cut out completely. New sealant can’t grip the old bead, so laying over it never lasts.
How do you keep disruption to occupiers down?
Phased work can be planned so areas stay in use. Tell us your site hours and access windows and we will plan around them.